UPS System, 2.2 kVA, 7 Outlets, Rack/Tower, Out: 120V AC , In:120V AC - SMART2200RMXLN

Description:

UPS System, Line Interactive, Power Rating 2.2 kVA, Wattage 1.95 kW, Input Voltage 120V AC, Output Voltage 120V AC, Backup Time (Half/Full Load) 12 min/4.5 min, Mounting Rack/Tower, Outlet Type UPS/Surge, Number of Outlets 7, Medical Grade No, NEMA Receptacle Configuration 5-15/20R, 5-15R, NEMA Plug Configuration 5-20P, Automatic Volts Regulation Yes, Fax/Modem Line Protection No, Transfer Time 1-4ms for Normal Mode, Width 17 in, Depth 24 in, Height 3 in, Cord Length 10 ft, Display Type LCD

Details:

Item : UPS System | UPS Type : Line Interactive | Power Rating : 2.2 kVA | Mounting : Rack/Tower | Wattage : 1.95 kW | Input Voltage : 120V AC | Output Voltage : 120V AC | Backup Time (Half/Full Load) : 12 min/4.5 min | Outlet Type : UPS/Surge | Medical Grade : No | Number of Outlets : 7 | Hz : 60 Hz | NEMA Receptacle Configuration : 5-15/20R, 5-15R | Transfer Time : 1-4ms for Normal Mode | Standards : UL | Phase : 1 | Special Features : Extended Run | NEMA Plug Configuration : 5-20P | Fax/Modem Line Protection : No | Display Type : LCD | Ports : DB9 Serial, EPO, USB | Automatic Volts Regulation : Yes | Includes : 4-Post Rack Mount Installation Kit, PowerAlert Software with USB, Serial and EPO Cables | Input Current : 16 A | Green Certification or Other Recognition : UL1778CSANOMFCC Part 15 Category B (EMI) | Capacity - Batteries : 2200 VA/1920 W | Input Connection : NEMA 5-20P Plug | Audible Alarm : Audible alarm indicates UPS startup, power-failure, low-battery, overload, UPS fault and remote shutdown conditions | Audible Noise : 45 dBA maximum, front side 1m | Overvoltage Correction : Voltage reduction of 12% applies when input is between 127 and 145 | EMI / RFI AC Noise Suppression : Yes | Output kW Capacity (kW) : 1.92 | Alarm Cancel Operation : Power-fail alarm can be temporarily silenced using alarm-cancel switch; silent mode alarm configuration option available | UPS AC Suppression Response Time : Instantaneous | Battery Replacement Description : Hot-swappable, user replaceable batteries | Recommended Electrical Service : 20A 120V | Switches : 3 pushbutton switches control OFF / ON power status, MODE selection and MUTE / ENTER control functions. LX Platform Interface: Recessed reset switch for interface reboot and factory reset | Battery Recharge Rate (Included Batteries) : 4.5 hours maximum from 10% to 90% (typical, full load discharge) | Network UPS Tools Compatibility : NUT compatible. See the full list of Tripp Lite NUT compatible UPS systems at http://www.networkupstools.org/stable-hcl.html?manufacturer=Tripp Lite | Primary Form Factor : Rackmount | PowerAlert Software : For local monitoring via the UPSâ„¢s built-in communication ports, download PowerAlert Local software at http://www.tripplite.com/poweralert. . LX Platform Interface: PowerAlert Device Manager 15 (PADM15). | Grounding Lug : Back panel grounding lug | Expandable Runtime : Yes | Input Phase : Single-Phase | Cooling Method : Fan | Output kVA Capacity (kVA) : 2.2 | High Availability UPS Features : Hot swappable batteries | Network Speed : 10/100 Mbps | Output Voltage Regulation (Battery Mode) : +/- 5% | Communications Interface : (1) DB9 Serial; (1) EPO (emergency power off); (1) Micro-USB; (1) Pre-installed network card; (1) RJ45 Network; USB (HID enabled); (1) USB-A; (1) USB-B | Operating Temperature Range : +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius | UPS Input Connection Type : 5-20P | Installation Form Factors Supported with Included Accessories : 4 post 19 inch rackmount | Expandable Battery Runtime : Extended runtime supported via optional external battery packs | Load Management Receptacles : Two switched single outlet load banks (1 5-15/20R & 1 5-15R) | Front Panel LCD Display : Front panel LCD information and configuration screen offers detailed UPS and site power status and operating data, plus configuration of voltage, operating mode, alarm function and a variety of additional options (see manual for detailed LCD configuration and monitoring options) | UPS Certification Details : SAFETY STANDARD (U.S.) - UL1778:2014 (5th Ed) R10.17; SAFETY STANDARD (CANADA) - CAN/CSA-C22.2 No. 107.3-14 (3rd Ed) + GI1 / FCC/ICES COMPLIANT - CLASS A | Internal UPS Replacement Battery Cartridge : RBC94-2U | Severe Undervoltage Correction : Voltage boost of 24% applies when input voltage is between 83 and 95 | DC System Voltage (VDC) : 48 | Low Voltage Transfer to Battery Power (Setpoint) : 83 | Output Capacity Details : Output is reduced to 1600 watts maximum when used with external battery packs | Nominal Voltage Details : 120v nominal output in battery mode | Battery Access : Front panel battery access door | Power Factor : 0.87 | Included Mounting Accessory Description : Included 4POSTRAILKIT mounting bracket enables installation in 4 post racks from 20.5 to 36 inches (521 to 914mm) | High Voltage Transfer to Battery Power (Setpoint) : 145 | Network Monitoring Port Description : Includes Pre-installed WEBCARDLX Network Management interface card. RJ45 Network port, Micro-USB Configuration/Console port, USB A port supports a variety of Envirosense2 environmental and control modules. See Accessories>Management Hardware section for more information about these modules. | UPS Certifications : Meets FCC Part 15 Category A (EMI); Tested to CSA (Canada); Tested to NOM (Mexico); Tested to UL1778 (USA) | LED Indicators : Network Link/Activity (Green): Flashes for network activity. Network Speed (Yellow): 10 Mbps (Flashing), 100 Mbps (On steady). LX Platform Interface Status: Normal Operation (Solid Green); Software Update (Alternating Green/Orange ~1/sec); Factory Reset (Alternating Green/Orange ~2/sec). | Output Receptacles : (4) 5-15R; (4) 5-15/20R | AC Mode BTU / Hr. (Full Load) : 306 | UPS AC Suppression Joule Rating : 570 | External Battery Pack Compatibility : BP48V24-2U (limit 1); BP48V60RT-3U (multi-pack compatible); BP48V27-2US (multi-pack compatible) | Output Volt Amp Capacity (VA) : 2200 | Frequency Compatibility : 60 Hz | Cold Start (Startup in Battery Mode During a Power Failure) : Cold-start operation supported | Output AC Waveform (AC Mode) : Pure Sine wave | UPS Housing Material : Steel | Rated input current (Maximum Load) : 16A | AC Mode Efficiency Rating (100% Load) : 0.96 | Installation Form Factors Supported with Optional Accessories : 2 post rackmount (2POSTRMKITWM); 4 post rackmount short-depth (4POSTRAILKITWM); Tower (2-9USTAND); Wallmount (2POSTRMKITWM) | Nominal Output Voltage(s) Supported : 110V; 115V; 120V | Output AC Waveform (Battery Mode) : Pure Sine wave | Individually Controllable Load Banks : Yes | WatchDog Compatibility : Supports Watchdog application, OS and hard-reboot restart options for remote applications | Relative Humidity : 5 to 95%, non-condensing | Nominal Input Voltage(s) Supported : 120V AC | Output Voltage Regulation (Line Mode) : -14%, +6% | Communications Cable : Micro-USB, USB, and DB9 cabling included | Storage Temperature Range : +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius | Voltage Regulation Description : Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 83 to 145 | EPO Port : RJ11 interface jack with 4-meter cable included. Supports normally open and normally closed EPO systems | Battery Mode BTU / Hr. (Full Load) : 1157 | Undervoltage Correction : Voltage boost of 12% applies when input voltage is between 96 and 108 | Output Watt Capacity (Watts) : 1920 | SNMP Compatibility : SNMP V1, V2c, V3 | Emergency Power OFF : Yes | Serial Port : Yes | Plug/Connector Type : NEMA 5-20P | Form Factor : Rack/Tower | TAA Compliant : Yes | Product Name : SMART2200RMXLN UPS System with Pre-installed SNMPWEBCARD | Certifications & Standards : UL1778, CSA, NOM, FCC Part 15 Category B (EMI) | Software Included : PowerAlert Software | USB : Yes | Network Management : SNMP Manageable | Receptacle Detail : 4 x NEMA 5-15R, 4 x NEMA 5-15/20R | Typical Battery Recharge Time : 4.50 Hour | Product Series : SmartPro | Package Contents : SMART2200RMXLN UPS system with Pre-installed SNMPWEBCARD, PowerAlert Software CD, USB Cable, Serial Cable, EPO Cable, 4 Post Installation Kit, Owner's Manual | Load Capacity : 1950 VA/1950 W | Hot Swappable : Yes

Dimensions:

Cord Length : 10 ft | Width : 17 in | Depth : 24 in | Height : 3 in | Rack Height : 2U | UPS Input Cord Length (ft.) : 10 | Minimum Required Rack Depth with External Battery Pack (in.) : 26.46 | Primary UPS Width (mm) : 440 | Primary UPS Depth (mm) : 494 | Primary UPS Height (mm) : 87 | Minimum Required Rack Depth without External Battery Pack (in.) : 24.46 | UPS Power Module Dimensions (hwd, in.) : 3.43 x 17.32 x 19.46